クラックアレスターを用いたき裂進展評価について

DOI Web Site

書誌事項

タイトル別名
  • Crack Onset Diagram using Crack Arrester
  • クラックアレスター オ モチイタ キレツ シンテン ヒョウカ ニ ツイテ

この論文をさがす

説明

Foam core sandwich panel structures are an excellent structural concept to realize full potential capabilities of composite materials owing to its high strength to weight and stiffness to weight ratio together with suitable formability for integral structures. However, degradation of strength due to the interfacial crack initiated from the damaged area is one of serious problems of this concept. Authors proposed the interfacial crack suppression method named the crack arrester. This concept is to install materials with higher stiffness on the crack propagation path and induce the redistribution of load between foam core area near the crack tip and the leading edge of the crack arrester in order to decrease energy release rate at the crack tip less than the interfacial fracture toughness. Crack suppression effect of the crack arrester were analytically estimated and experimentally validated under mixed mode of mode I and mode II, and mode III loading conditions. As for the analyses, it was confirmed that the energy release rates at crack tip decreased as crack tip approached the leading edge of the arrester under constant loadings. In the experimental validation, fracture toughness tests were conducted and apparent fracture toughness increased as crack tip approached the leading edge of the arrester. Based on the acquired apparent fracture toughness derived from test data, a crack onset estimation method was proposed and a crack onset diagram was prepared in order to apply this concept to structural design.

収録刊行物

  • 材料システム

    材料システム 30 (0), 21-26, 2012

    学校法人 金沢工業大学 材料システム研究所

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ