SEISMIC RESPONSE REDUCTIOS FOR CYLINDRICAL LATTICE SHELL ROOFS BY PLURAL TMDS INSTALLING IN ROOF STRUCTURE AND SUPPORTING SUBSTRUCTURE DISTRIBUTED FOR PURPOSE OF DISPERSING LOADS

DOI Web Site 4 References
  • KUMAGAI Tomohiko
    Dept. of Arch., School of Science and Technology, Meiji University
  • TAKAHASHI Haru
    Dept. of Arch. and Urbanism Eng., Graduate School of Science and Engineering, Meiji University
  • KUROSAKI Shun
    Dept. of Arch. and Urbanism Eng., Graduate School of Science and Engineering, Meiji University

Bibliographic Information

Other Title
  • 屋根面の荷重負担分散を考慮して屋根面と下部構造に設置したTMDによる屋根型円筒ラチスシェルの地震応答低減

Abstract

<p>TMD (Tuned Mass Damper) is fit for the vibration control of a spatial structure because it is possible to install the TMDs by a single supporting point. Therefore, there are many studies on the vibration control for a spatial structure by TMDs. However, the effects of degrees of connections at joints between roof structure and supporting substructure on the vibration modes controlled by installing TMDs are not examined. In addition, depending on the half open angles of roof structures, multiple TMDs are concentrated at a single node by the antinodes of multiple controlled modes overlapping. As a results the stresses of members near that node may increase. Therefore, this paper is intended as an investigation of the effects of changes in degrees of connection between roof structure and supporting substructure and the effects of distributed installation of multiple TMDs installed on roof structure and supporting substructure for purpose of dispersing loads at nodes of roof on the response reduction effects by TMDs for cylindrical lattice shell roofs.</p>

Journal

References(4)*help

See more

Keywords

Details 詳細情報について

Report a problem

Back to top