Effects of Electrolyte Composition and Additives on the Formation of Invar Fe–Ni Alloys with Low Thermal Expansion Electrodeposited from Sulfate Bath
-
- Kashiwa Yuki
- Department of Life Science, Kyushu Sangyo University
-
- Nagano Nobuaki
- Department of Materials Science, Kyushu Institute of Technology
-
- Takasu Tomio
- Department of Materials Science, Kyushu Institute of Technology
-
- Kobayashi Shigeo
- Department of Life Science, Kyushu Sangyo University
-
- Fukuda Keisuke
- Department of Materials Process Engineering, Kyushu University
-
- Nakano Hiroaki
- Faculty of Engineering, Kyushu University
Abstract
<p>The effects of solution composition and additives on the formation of electrodeposited invar Fe–Ni alloys with low thermal expansion were investigated. In all solutions, increasing the current density from 10 A·m−2 significantly decreased the Ni content in the deposits and resulted in anomalous codeposition, in which the electrochemically less noble Fe was preferentially deposited. Further increasing the current density increased the Ni content in the deposits as Fe deposition reached the diffusion limitation of the Fe2+ ions. Increasing the concentration of Fe2+ ions increased the current density required to initiate an increase in the Ni content in the deposits because of increase in the diffusion-limited current density of Fe. With the increasing concentration of malonic acid, the current density region in which Ni deposition was suppressed was extended, and the potential at which Fe deposition reached the diffusion limitation of the Fe2+ ions was shifted to a less noble direction. As a result, the relationship between the Ni content in the deposits and the current density shifted to a higher-current-density region with increasing malonic acid concentration. At malonic acid concentrations above 0.05 mol·dm−3, the current efficiency for alloy deposition was greatly reduced owing to the promotion of hydrogen evolution. The Ni content in the deposits was significantly increased with the addition of thiourea. Boric acid somewhat increased the Ni content in the deposits in the lower-current-density region. In solutions containing both boric acid and saccharin, an invar alloy of 36 mass% Ni was obtained in the wider-current-density region.</p>
Journal
-
- ISIJ International
-
ISIJ International 59 (3), 514-523, 2019-03-15
The Iron and Steel Institute of Japan
- Tweet
Keywords
Details
-
- CRID
- 1390564238080319872
-
- NII Article ID
- 130007615804
-
- ISSN
- 13475460
- 09151559
-
- Text Lang
- en
-
- Data Source
-
- JaLC
- Crossref
- CiNii Articles
-
- Abstract License Flag
- Disallowed