ハンマ鍛造におけるワーク跳躍メカニズムの解明

書誌事項

タイトル別名
  • Elucidation of Mechanism Underlying Workpiece Jump in Hammer Forging
  • ハンマ タンゾウ ニ オケル ワーク チョウヤク メカニズム ノ カイメイ

この論文をさがす

抄録

<p>During the process of drop hammer forging, workpieces sometimes jump after strikes. The present research investigates the mechanism of the workpiece jump by means of experiments and numerical simulations. In the experiments, workpieces were struck by vertical symmetrical flat dies or vertical asymmetrical dies. A high-speed camera was used to measure the workpiece deformation, the position of workpieces during jumping and the position of the dies. Strain of lower dies and structures of the hammer were measured by strain gauges. Vibration of the antirattler under the hammer, elastic vibration of lower dies and structures of the hammer, and contact area between workpieces and dies were analyzed by numerical simulations. The results indicate that workpieces jump by adhesive force between workpieces and dies, and by elastic vibration of lower dies and structures of the hammer.</p>

収録刊行物

  • 塑性と加工

    塑性と加工 62 (721), 21-28, 2021

    一般社団法人 日本塑性加工学会

参考文献 (11)*注記

もっと見る

詳細情報 詳細情報について

問題の指摘

ページトップへ