研磨材濃度の安定化によるアブレシブ・サスペンション・ジェット切断加工への影響

DOI Web Site

書誌事項

タイトル別名
  • Effect of Stabilized Abrasive Concentration on Suspension Jet Cutting

抄録

<p>Abrasive-water suspension jets (ASJs) which jet out the suspension mixed water and abrasive in advance are excellent even at relatively low pressure. Although ASJs system by bypass system is advantageous in terms of equipment maintenance and cost as the jetting time increases the abrasive concentration in the vessel decreases, since high pressure water directly flows into the vessel and pushes out the suspension. In this study, we aim to stabilize the abrasive concentration by the bypass system which has a merit in terms of cost and simple structure and perform highly accurate cuttings. The stabilization of the abrasive concentration was adjusted by changing the opening of the valve attached in the bypass pipeline and changing the flow rate over time. The change in the flow rate was made based on the equation derived from the equation by formulating the change in the abrasive concentration in the suspension vessel by the differential equation. We conducted a cutting experiment using a 0.3 mm thick aluminum plate under stable abrasive concentration conditions.As a results, although the cut width decreased without stabilization adjustment, when the valve opening was adjusted, the cutting width became almost stable.</p>

収録刊行物

  • 年次大会

    年次大会 2020 (0), S05409-, 2020

    一般社団法人 日本機械学会

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ