各種難燃性マグネシウム合金切粉の発火特性および粉じん爆発特性

  • 千野 靖正
    国立研究開発法人産業技術総合研究所 マルチマテリアル研究部門
  • 鈴木 一孝
    国立研究開発法人産業技術総合研究所 マルチマテリアル研究部門
  • 黄 新胜
    国立研究開発法人産業技術総合研究所 マルチマテリアル研究部門
  • Bian Mingzhe
    国立研究開発法人産業技術総合研究所 マルチマテリアル研究部門
  • 石川 武
    株式会社総合車両製作所
  • 清水 和紀
    三協立山株式会社
  • 上田 祐規
    不二ライトメタル株式会社

書誌事項

タイトル別名
  • Ignition and dust explosion properties of machined chips of various flame retardant magnesium alloys
  • カクシュ ナンネンセイ マグネシウム ゴウキン キリコ ノ ハッカ トクセイ オヨビ フンジン バクハツ トクセイ

この論文をさがす

抄録

<p>Ignition temperatures and dust explosion properties (minimum explosible concentration and minimum ignition energy) of machined chips of flame retardant magnesium alloys (AZX611 (Mg-6Al-1Zn-1Ca, mass%), AXM4102 (Mg-4Al-1Ca-0.2Mn) and AZX912 (Mg-9Al-1Zn-2Ca)) and aluminum alloy (A6005C (Al-0.6Si-0.6Mg)) were investigated. Ignition temperature of the flame-retardant magnesium alloy chips (<300 μm) measured by DTA (Differential Thermal Analysis) slightly increased with increasing calcium concentration, regardless of particle size of chips. As a result of the tests of minimum explosible concentration, the flame-retardant magnesium alloys exhibited significantly lower values than A6005C. In particular, AZX912 had lower value than the other magnesium alloys, due to smaller particle size of the AZX912 chips than the other magnesium alloys. The minimum ignition energy of AZX611 and A6005C was also evaluated. As a result, a significantly lower value was observed in AZX611 compared to A6005C. On the other hand, the value of AZX611 was higher than the literature value due to larger particle size. A series of experiments indicated that the dust explosion properties were strongly dependent on particle size rather than alloy composition (calcium concentration).</p>

収録刊行物

  • 軽金属

    軽金属 74 (2), 125-130, 2024-02-15

    一般社団法人 軽金属学会

参考文献 (17)*注記

もっと見る

詳細情報 詳細情報について

問題の指摘

ページトップへ