書誌事項
- タイトル別名
-
- Influence of Stress Factor on Void Closure
- 空隙閉鎖に及ぼす応力因子の影響 : 大型鋼塊の空隙閉鎖に関する研究(第3報)
- クウゲキ ヘイサ ニ オヨボス オウリョク インシ ノ エイキョウ : オオガタ コウカイ ノ クウゲキ ヘイサ ニ カンスル ケンキュウ(ダイ3ポウ)
- ―大型鋼塊の空隙閉鎖に関する研究 第3報―
- ―Study on Void Closure of Large Steel Ingot, 3rd Report―
この論文をさがす
説明
<p>In the 2nd report, the evaluation factors for void closure under the condition of multipass forging revealed that true strain εz in the z direction is appropriate for the evaluation factors for void closure. However, although the effectiveness of the hydrostatic stress ratio σm /σeq for void closure was clear in the 1st report, the reasons were not clarified. In this paper, we investigated the effects of stress factors on void closure and its handling through numerical experiments. The following results were obtained. 1) By using the true stress in each direction, the deformation behavior of voids can be evaluated as a dimensional change of the diameter on the basis of the frictionless model. 2) In the z stroke direction, the void is easier to close than in the frictionless model when σz /σeq is -1 or less, and harder to close than in the frictionless model if not. 3) The void diameter in the x direction, dx , is smaller than in the frictionless model when σx /σeq is 0 or less, and larger than in the frictionless model if not. 4) When there is a void on the axis of symmetry, σm /σeq can be used to evaluate εz for void closure and the dimensional change of dx . In addition, we clarified the influences of material size, void size, and mechanical properties of the material on void closure.</p>
収録刊行物
-
- 塑性と加工
-
塑性と加工 59 (691), 149-157, 2018
一般社団法人 日本塑性加工学会
- Tweet
キーワード
詳細情報 詳細情報について
-
- CRID
- 1390845712994320768
-
- NII論文ID
- 130007458310
-
- NII書誌ID
- AN00135062
-
- ISSN
- 18820166
- 00381586
-
- NDL書誌ID
- 029220447
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- NDL
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可