ASA150~2500に対応する短繊維強化FRPフランジの設計(第1報)

書誌事項

タイトル別名
  • FRP flange design by CS material (Part 1): ASA150-ASA2500

この論文をさがす

説明

Since the range of application of flanges made of FRP material is required to be shared with flanges made of existing steel material, ASA 150 to 2500 of international standard and pipe diameter of 25 to 3800 mm are used. FRP flanges consist of two types, one consisting of short fiber reinforced material (hereinafter referred to as CS) and the other consisting of continuous fibers (hereinafter referred to as Roving). For flanges made of CS, compression molding and centrifugal molding method are applied. Filament winding (FW molding method) is applied for the flange consisting of Roving. This report describes research results on the design standard of ASA 150 to 2500 applied flange using CS material

収録刊行物

  • GPI Journal

    GPI Journal 4 (1), 7-12, 2018

    一般社団法人 GPI標準化委員会

詳細情報 詳細情報について

  • CRID
    1390845713025716736
  • NII論文ID
    130007540868
  • DOI
    10.24570/gpijournal.4.1_7
  • ISSN
    24334510
    21893373
  • 本文言語コード
    ja
  • データソース種別
    • JaLC
    • CiNii Articles
  • 抄録ライセンスフラグ
    使用不可

問題の指摘

ページトップへ