[Updated on Apr. 18] Integration of CiNii Articles into CiNii Research

Curling of Sheet in Asymmetric Rolling Investigated by Profile Measurement of Partly Rolled Sheet

  • Li Ling
    Division of Materials and Manufacturing Science, Graduate School of Engineering, Osaka University
  • Matsumoto Ryo
    Division of Materials and Manufacturing Science, Graduate School of Engineering, Osaka University
  • Utsunomiya Hiroshi
    Division of Materials and Manufacturing Science, Graduate School of Engineering, Osaka University

Abstract

<p>The curling of a sheet in cold asymmetric rolling was investigated experimentally by interrupted rolling. Influences of speed difference as well as entry table height were studied. The upper and lower profiles of the aluminum sheet obtained by interrupted rolling were measured by a laser profilometer. The contact lengths on both upper and lower surfaces LU and LL were detected from the profiles. The curvature radius of sheet was calculated from the curling profiles. Under differential-speed rolling, the sheet curled to the slower roll side at low reduction in thickness, while it curled to the faster roll side at higher reduction. Meanwhile, LU on the faster (upper) roll surface was longer than LL on the slower (lower) roll surface at low reduction. On the other hand, LU was shorter than LL at higher reduction in thickness. It is found that the ratio of contact length LL/LU is correlated with the curling direction in the differential-speed rolling. If LL/LU < 1, the sheet curls towards the slower roll side, while the sheet curls towards the faster roll side in case of LL/LU > 1.</p>

Journal

  • ISIJ International

    ISIJ International 59 (3), 489-495, 2019-03-15

    The Iron and Steel Institute of Japan

Citations (0)*help

See more

References(8)*help

See more

Related Articles

See more

Related Data

See more

Related Books

See more

Related Dissertations

See more

Related Projects

See more

Related Products

See more

Details

Report a problem

Back to top