書誌事項
- タイトル別名
-
- Influence of gas blow on high-speed cutting of Inconel 718 by ceramic end mill
説明
Machinability of Inconel 718 is remarkably poor, so cutting is carried out in the low speed region at the production site. On the other hand, in recent years, high-efficiency cutting by using a ceramic end mill has been put to practical use in rough machining, but there are some problems such as welding on tools, short tool life, poor finished surface. In this study, the influence of gas blow supply to cutting point on welding and tool life in high-speed cutting of Inconel 718 was investigated.
収録刊行物
-
- 生産加工・工作機械部門講演会 : 生産と加工に関する学術講演会
-
生産加工・工作機械部門講演会 : 生産と加工に関する学術講演会 2018.12 (0), C15-, 2018
一般社団法人 日本機械学会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390845713064240384
-
- NII論文ID
- 130007637816
-
- ISSN
- 24243094
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- Crossref
- CiNii Articles
- OpenAIRE
-
- 抄録ライセンスフラグ
- 使用不可