Oxygen Evolution Overpotential of Pb-based Insoluble Anode Containing Ru Oxide Powders Prepared by Liquid-phase Reaction and Heating

TAKAHASHI Hiroki, OZAWA Yuuji, OHKUBO Keisuke, TAGUCHI Masami, SUZUKI Kazunari

doi:10.5188/ijsmer.24.6

<p>Ruthenium oxide powders were produced by the reaction of an RuCl₃ solution with H₂O₂, followed by heating of the resulting precursor at a temperature between 200°C and 600°C in air. Pb-based anodes containing these heated products of 1.0 mass% were prepared by the powder-rolling method, and the effect of the heated product as an electrode catalyst on lowering the anode potential was investigated in order to develop an energy-saving insoluble anode for Zn electrowinning. Based on XPS results, RuO₂ with a signifi cant amount of RuO₂･nH₂O was produced by heating the precursor at 250°C or lower. The ratio of RuO₂ to RuO₂･nH₂O increased remarkably above 300°C and the potential of the Pb-based anode decreased in inverse proportion to the RuO₂ content of the heated product. The lowest anode potential of 1.72 V vs. NHE, which was about 360 mV lower than that of the anode with the unheated precursor, was observed for the Pb-based anode containing the product heated at 400°C. However, the anode potential of the Pb-based anode increased again when the heating temperature was 500°C or higher. The subsequent increase in the anode potential was probably caused by a decrease in the active sites of the oxygen evolution reaction, that is, the grain growth of the heated product decreased the effective reaction area of the RuO₂ catalyst.</p>

Oxygen Evolution Overpotential of Pb-based Insoluble Anode Containing Ru Oxide Powders Prepared by Liquid-phase Reaction and Heating

Search this article

Description

Journal

References(12)*help

Related Projects

Keywords

Details 詳細情報について

Export

Report a problem