回転水中紡糸法で製造された金属細線の形態に及ぼす製線条件の影響

DOI HANDLE Web Site 被引用文献1件 オープンアクセス

書誌事項

タイトル別名
  • Effect of Spinning Condition on the Shape of Metal Wire Produced by the In-Rotating-Water Spinning Method
  • カイテン スイチュウ ボウシホウ デ セイゾウサレタ キンゾク サイセン ノ

この論文をさがす

抄録

Metal wires of Pb, Zn and Fe_<77.5>Si_<7.5>B_<15> were produced by the In-Rotating-Water Spinning Method. The effects on the shape of wire of drum velocity (5.2-8.5m/s), jet ejection velocity (3.5-10.0m/s), incidence angle (30, 45, 60 deg) and nozzle diameter (0.1 and 0.2mm) as well as the kind of metals were examined. Pb showed the best spinnability among the tested metals, although the cross section was relatively flat and marked ripples were formed on the wire surface when the incidence angle and jet velocity were relatively large. A long, straight Fe_<77.5>Si_<7.5>B_<15> wire that had smooth surface and round cross-section was obtained with a 0.2-mm-dia. nozzle when the jet velocity and the drum velocity were almost the same. The Fe_<77.5>Si_<7.5>B_<15> wire produced with a 0.1-mm-dia. nozzle however showed the shape like a string of beads.

収録刊行物

被引用文献 (1)*注記

もっと見る

詳細情報 詳細情報について

問題の指摘

ページトップへ