P-06　各種スギ粉砕粉末とABS樹脂の混合による3Dプリントフィラメントの開発

DOI

書誌事項

タイトル別名
  • P-06　Development of 3D Printing filament from mixing various pulverized Japanese cedar powder with ABS

説明

<p>In this study, Japanese cedar powder pulverized by vibration mill with ring media was blended with ABS and molded into filament for fused deposition modeling 3D printer. The Japanese ceder powder was either pulverized only or acetylated. The content of pulverized and acetylated powders were varied in the mold experiments. The results showed that as the pulverized powder content in the blended filaments increased, the average diameter increased and the strength decreased. The acetylated powder suppressed these changes. Cross-sectional observation showed clumping of pulverized powder. The blending conditions are considered to be inadequate, so this is an issue for the future.</p>

収録刊行物

詳細情報 詳細情報について

  • CRID
    1390853879745836928
  • NII論文ID
    130008150738
  • DOI
    10.20550/jiebiomassronbun.17.0_59
  • ISSN
    24238341
    24238333
  • 本文言語コード
    ja
  • データソース種別
    • JaLC
    • CiNii Articles
  • 抄録ライセンスフラグ
    使用不可

問題の指摘

ページトップへ