Effect of Fabrication Parameter on Microstructure of Mg–5.3 mass%Al–3 mass%Ca for Development of Mg Rechargeable Batteries

DOI Web Site Web Site 被引用文献4件 参考文献11件
  • Tsukeda Tadayoshi
    Department of Materials Design and Engineering, Faculty of Sustainable Design, University of Toyama
  • Nakagawa Takuro
    Department of Materials Design and Engineering, Faculty of Sustainable Design, University of Toyama
  • Moriwaki Masaya
    Department of Materials Design and Engineering, Faculty of Sustainable Design, University of Toyama
  • Kikura Kensei
    Department of Materials Design and Engineering, Faculty of Sustainable Design, University of Toyama
  • Sakurae Riku
    Department of Materials Design and Engineering, Faculty of Sustainable Design, University of Toyama
  • Aida Tetsuo
    Department of Materials Design and Engineering, Faculty of Sustainable Design, University of Toyama
  • Tabata Hironobu
    Advanced Technology Laboratory, Chuetsu Metal Works Co., Ltd.
  • Kurihara Hideki
    Saitama Industrial Technology Center
  • Suzuki Mayumi
    Department of Mechanical Systems Engineering, Faculty of Engineering, Toyama Prefectural University

この論文をさがす

抄録

<p>Various motor using transportation system in land-sea-air, high speed mobile terminal with 5G specification, and renewable energy storage equipment have required innovative metal rechargeable batteries compared with lithium ones. In particular, magnesium has huge potentialities as an anode material from the standpoint of its theoretical volumetric capacity superior to that of lithium. Secondly, magnesium has been one of the most abundant elements in the Earth’s crust. Moreover, the potential safety by short-circuiting evading with non-dendritic deposition of magnesium. In general, magnesium-based ribbon as an anode has been manufactured by cold rolling which requires multistage process including heat treatment. We have studied rapid liquid quenching process in order to develop low-cost manufacturing technique. On the other hand, we have focused Mg–6 mass%Al–3 mass%Ca alloy due to this unique microstructure which consist of primary crystals and intermetallic compounds along grain boundary. In addition, calcium has affected to prevent of molten magnesium burning in air atmosphere. The structural properties and surface morphology are investigated by XRD and Digital Microscope, respectively. Microstructure has been observed by FE-SEM and FE-TEM. Moreover, these electrochemical properties have been examined by constant current charge - discharge tests using 3 electrodes type cell. Mg–3 mass%Al–1 mass%Zn alloy cold rolled thin plate has been investigated as comparison. The ribbons that exhibited electrochemical properties had a fine microstructure. It is suggested that the grain refinement and dispersion of the second phase are important to improve the charge-discharge properties of Mg–Al–Ca based anode materials.</p>

収録刊行物

  • MATERIALS TRANSACTIONS

    MATERIALS TRANSACTIONS 63 (4), 408-414, 2022-04-01

    公益社団法人 日本金属学会

被引用文献 (4)*注記

もっと見る

参考文献 (11)*注記

もっと見る

関連プロジェクト

もっと見る

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ