二組の穴とボスとを用いた位置決めによる組立ばらつきの解析
書誌事項
- タイトル別名
-
- Analysis of Assembly Variation between Two Parts Constrained using Hole and Boss Features
- (2nd Report, Derivation of the Diameter of the Circle Circumscribing the Rattling Area)
- （第2報，がたの領域に外接する円の半径の導出）
説明
<p>This paper discusses the assembly variation that can arise when the positioning between two parts is constrained using two holes that fit over two bosses. Two parts positioned using two holes fitting over two bosses may move relative to each other during assembly because of slight clearances between the boss-hole pairs. In many cases, two boss-hole clearances are toleranced equally, resulting a motion which is more complex than simple translation or rotation. In thispaper, the region where a certain point can move due to rattling is called “rattling area”, and the formula for the diameterof the circle circumscribing the rattling area is derived. Furthermore, a drawing experiment was conducted to verify the calculation of the circumscribed circle.</p>
収録刊行物
-
- 設計工学
-
設計工学 57 (12), 607-620, 2022
公益社団法人 日本設計工学会
- Tweet
キーワード
詳細情報 詳細情報について
-
- CRID
- 1390857280106107392
-
- ISSN
- 21889023
- 09192948
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
-
- 抄録ライセンスフラグ
- 使用不可
