冷間圧延りん青銅板における非熱的応力成分の評価

DOI

書誌事項

タイトル別名
  • Evaluation of the Athermal Stress Component in Cold Rolled Phosphor Bronze Sheet for Springs

抄録

<p>When considering the strength required for structural materials, the first requirement is the ability to permanently hold stress under static loads. In order to achieve carbon neutrality, there is a need for lean and extreme design. It is important to evaluate the flow stress by removing the strain rate dependence of the material from the results of uniaxial tensile tests at quasi–static strain rates. In this study, the athermal stress component (stress independent on strain rate) of cold–rolled phosphor bronze sheet for springs (JIS–C5210–H) was evaluated using stress relaxation tests and extrapolation by curve fitting. It was found that about 90% of the 0.2% proof stress observed in the uniaxial tensile test at quasi–static strain rate was the athermal stress component. It was also found that the thermal stress component (stress dependent on strain rate) accounted for about 10% and could not be generally ignored. Therefore, it is suggested that evaluation of the athermal stress component is effective as one of the direct methods to evaluate the static strength of structural materials.</p>

収録刊行物

関連プロジェクト

もっと見る

詳細情報 詳細情報について

  • CRID
    1390857368728974464
  • DOI
    10.34562/jic.61.1_130
  • ISSN
    2435872X
    13477234
  • 本文言語コード
    ja
  • データソース種別
    • JaLC
    • KAKEN
  • 抄録ライセンスフラグ
    使用可

問題の指摘

ページトップへ