エンジン油中でのSUJ2と銅合金の摩擦におけるトライボフィルム生成に及ぼす銅合金組成の影響
書誌事項
- タイトル別名
-
- Effect of Chemical Composition in Copper Alloy on Tribofilm Formation under Friction Test between SUJ2 and Copper Alloy in Engine Oil
抄録
<p>In recent years, the viscosity of engine oils gets lower and cylinder pressure gets higher to improve thermal efficiency of internal combustion engines. Therefore, engine bearings are increasingly used in the boundary lubrication region with the decrease in oil film thickness, and it is necessary to improve seizure resistance and fatigue resistance. On the other hand, MoDTC and ZnDTP are widely used in engine oils to reduce friction and prevent seizure in the boundary lubrication region. It is well known that their effects are different depending on conditions such as sliding materials. However, there are few studies on copper alloys used in engine bearings. So, it is required to understand the effects of copper alloys on friction in engine oils. In this study, effect of chemical composition in copper alloy on tribofilm formation are investigated by using a ball-on-disk type sliding tester in lubricating oils with ZnDTP and MoDTC. As a result, solid solution strengthening components of copper such as Sn, Ni affected tribofilm formation and running-in. In particular, Ni is highly reactive and promoted tribofilm formation. In addition, Bi contained copper alloy can obtain low friction after running-in due to the oriented MoS₂on the top surface.</p>
収録刊行物
-
- トライボロジスト
-
トライボロジスト 68 (8), 567-576, 2023-08-15
一般社団法人 日本トライボロジー学会
- Tweet
キーワード
詳細情報 詳細情報について
-
- CRID
- 1390860078756152704
-
- ISSN
- 21899967
- 09151168
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
-
- 抄録ライセンスフラグ
- 使用不可