Al-Zn-Mg合金の微細組織形成に及ぼす焼き入れ速度の影響

  • 愛須 優輝
    株式会社UACJ マーケティング・技術本部 R&D センター
  • 一谷 幸司
    株式会社UACJ マーケティング・技術本部 R&D センター
  • 田中 宏樹
    株式会社UACJ マーケティング・技術本部 R&D センター
  • 齊藤 元貴
    名古屋大学大学院工学研究科物質科学専攻
  • 武藤 俊介
    名古屋大学大学院工学研究科物質科学専攻 名古屋大学未来材料・システム研究所高度計測技術実践センター
  • 岡島 敏浩
    公益財団法人科学技術交流財団あいちシンクロトロン光センター

書誌事項

タイトル別名
  • Effect of quenching rate on microstructure formation in Al-Zn-Mg alloy sheet
  • Al-Zn-Mg ゴウキン ノ ビサイ ソシキ ケイセイ ニ オヨボス ヤキ イレ ソクド ノ エイキョウ

この論文をさがす

抄録

<p>A phenomenon that Al-6.0%Zn-0.75%Mg alloy sheets furnace-cooled after solution heat treatment had higher strength than water-quenched sheets under specific aging condition was reported. However, the strengthening mechanism related to furnace-cooling had been not clarified yet. In this research, replication test of the strengthening phenomenon of furnace-cooled sheets and the microstructural change during natural aging and artificial aging at 200°C after furnace-cooling after solution heat treatment was investigated by tensile tests, SAXS measurements, STEM observation and electrical conductivity measurement. The strengthen phenomenon of furnace-cooled sheets was reproduced. In as-furnace-cooled sheets, 2-5 nm clusters which induced lattice strain were observed in LAADF-STEM image apart from atomic number contrast in HAADF-STEM image. The clusters seemed to be generated during furnace cooling. The clusters seemed to cause suppression of reversion and promotion of age hardening in furnace-cooled material.</p>

収録刊行物

  • 軽金属

    軽金属 73 (12), 616-621, 2023-12-15

    一般社団法人 軽金属学会

参考文献 (8)*注記

もっと見る

詳細情報 詳細情報について

問題の指摘

ページトップへ