Effect of Rolling and Alloying Elements on the Impact Properties of Hypereutectoid Steels

  • Tokunaga Toko
    Department of Physical Science and Engineering, Nagoya Institute of Technology
  • Minamino Yoritoshi
    Professor Emeritus, Department of Adaptive Machine Systems, Graduate School of Engineering, Osaka University
  • Yamamoto Koji
    Power Train Group, Manufacturing Engineering Development Center, Komatsu Ltd.
  • Sugimoto Toshiyuki
    Product Development Group-I, New Product Development Office, Research & Development Center, Sanyo Special Steel Co., Ltd.
  • Hagihara Koji
    Department of Physical Science and Engineering, Nagoya Institute of Technology Division of Materials and Manufacturing Science, Graduate School of Engineering, Osaka University

抄録

<p>In this study, to develop steel with high strength and ductility, steels are designed based on JIS-SUJ2 hypereutectoid steel by controlling the contents of the alloying elements Cr and Mn. The steels are subjected to two types of specially designed heat treatment, i.e., “grain boundary amelioration (GBA)” treatment, with and without rolling. The effects of the alloy type and rolling on the microstructure and impact properties are investigated. High impact values over 50 J/cm2 were achieved compared to those of conventional steels by the significant refinement of γ grains with GBA treatment. All the steels exhibit transgranular fracture, and no intergranular fracture was observed. This indicates that the proposed heat treatment achieved the suppression of intergranular fracture by inhibiting the formation of θ particles on the grain boundaries and by refining the prior γ grains. Moreover, it has been suggested that the impact values were strongly affected by the C content in the matrix which is controlled by the alloying element and by the heat treatment. As the C content increases, hardness and fraction of the retained γ phase increase, which leads to the decrease in impact value. In samples where prior γ grains were extremely fine and θ particles were fine, area fraction and circularity of the θ particles did not have a significant effect on the impact values.</p>

収録刊行物

参考文献 (32)*注記

もっと見る

詳細情報 詳細情報について

問題の指摘

ページトップへ