Formation of a Diffusion Barrier Coating on Ni-Based Alloy and Thermal Cycle Oxidation Property

DOI Web Site Web Site 参考文献7件

この論文をさがす

抄録

<p>A diffusion-barrier coating layer (DBC) was formed on a Ni–22Cr–19Fe–9Mo alloy by Al-pack cementation at 1000°C followed by heat treatment at 1100°C. The thermal cyclic oxidation behavior of the DBC system was then investigated. The thermal cycle oxidation tests were conducted at 1100°C in air for 45 min, each followed by 15 min at room temperature. Electron probe micro-analysis (EPMA) was performed to determine the microstructure and concentration profile of each element between the substrate and the coating layer.</p><p>The DBC system showed good thermal cycle oxidation property. The layer structure between the substrate and the coating layer after thermal oxidation cycling is discussed with respect to the composition paths plotted in the Ni–Cr–Fe and Ni–Cr–Al phase diagrams. The coating layer structure after 100 cycles of 45 min at 1100°C consisted of the γ- and α-phases of the Ni–Cr–Fe system and the β-phase of the Ni–Cr–Al system. The coating layer structure after 400 cycles of 45 min at 1100°C consisted of the γ-phase of the Ni–Cr–Fe system and the β-phase of the Ni–Cr–Al system. In contrast, the coating layer structure after 900 cycles of 45 min at 1100°C consisted of the γ-phase of the Ni–Cr–Fe system.</p><p> </p><p>This Paper was Originally Published in J. Japan Inst. Met. Mater. 83 (2019) 372–377.</p>

収録刊行物

  • MATERIALS TRANSACTIONS

    MATERIALS TRANSACTIONS 61 (12), 2336-2341, 2020-12-01

    公益社団法人 日本金属学会

参考文献 (7)*注記

もっと見る

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ