A Simple Method for Separating Dissipation Factors in Microwave Printed Circuit Boards (Special Issue on Measurement Techniques for Microwave/Millimeter Wave)

この論文をさがす

説明

A simple method for separating the dissipation factors associated with both conductor losses and dielectric losses of printed circuit boards in microwave frequencies is presented. This method utilizes the difference in dependence of two dissipation factors on the dimensions of bounded stripline resonators using a single printed circuit board specimen as a center strip conductor. In this method, the separation is made through a procedure involving the comparison of the measured values of the total dissipation factor with those numerically calculated for the resonators. A method, which is based on a TEM wave approximation and uses Green's function and a variational principle, is used for the numerical calculation. Both effective conductivity for three kinds of industrial copper conductor supported with a substrate of polyimide film and dielectric loss tangent of the substrates are determined using this method from the values of the unloaded Q measured at the 10 GHz region. Radiation losses from the resonator affecting the accuracy of the separation are discussed, as well as the values of the effective conductivity of metals on the polyimide substrate which is calculated using the above method. The resulting values of the effective conductivity agree with those using the triplateline method within 10%.

収録刊行物

キーワード

詳細情報 詳細情報について

  • CRID
    1570291227387753600
  • NII論文ID
    110003220425
  • NII書誌ID
    AA10826283
  • ISSN
    09168524
  • 本文言語コード
    en
  • データソース種別
    • CiNii Articles

問題の指摘

ページトップへ