Characterization of 10 μm Thick Porous Silicon Dioxide Obtained by Complex Oxidation Process for RF Application

参考文献11件
  • PARK Jeong-Yong
    School of Electrical Engineering and Computer Science, Kyungpook National University
  • LEE Jong-Hyun
    School of Electrical Engineering and Computer Science, Kyungpook National University

この論文をさがす

説明

This paper proposes a 10μm thick oxide layer structure, which can be used as a substrate for RF circuits The structure has been fabricated by anodic reaction and complex oxidation, which is a combined process of low temperature thermal oxidation (500℃, for 1hr at H_2O/O_2) and a rapid thermal oxidation (RTO) process (1050℃, for 1mm) The electrical characteristics of oxidized porous silicon layer (OPSL) were almost the same as those of standard thermal silicon dioxide The leakage current through the OPSL of 10μm was about 100-500pA in the range of 0V to 50V The average value of breakdown field was about 3.9MV/cm From the X-ray photo-electron spectroscopy (XPS) analysis, surface and internal oxide films of OPSL, prepared by complex process, were confirmed to be completely oxidized Also the role of RTO was important for the densification of the porous silicon layer (PSL), oxidized at a lower temperature For the RF test of Si substrate, with thick silicon dioxide layer, we have fabricated high performance passive devices such as coplanar waveguide (CPW) on OPSL substrate The insertion loss of CPW on OPSL prepared by complex oxidation process was -0.39dB at 4GHz and similar to that of CPW on OPSL prepared at a temperature of 1050℃ (1hr at H_2O/O_2). Also the return loss of CPW on OPSL prepared by complex oxidation process was -23dB at 10GHz which is similar to that of CPW on OPSL prepared by high temperature oxidation.

収録刊行物

参考文献 (11)*注記

もっと見る

キーワード

詳細情報 詳細情報について

  • CRID
    1570572702511807360
  • NII論文ID
    110003214549
  • NII書誌ID
    AA10826283
  • ISSN
    09168524
  • 本文言語コード
    en
  • データソース種別
    • CiNii Articles

問題の指摘

ページトップへ