J-3-6-359 自動演奏ベルのうなり音抑制の研究(J-3-6:楽器・音質・評価,領域3:振動・騒音,総合テーマ「海を越え,国を越え,世代を超えて!」)

書誌事項

タイトル別名
  • J-3-6-359 Study on the beat sound control of the automatically performing bell

この論文をさがす

説明

An automatically performing bell system, which informs the specified time with music, has many types of bell configuration and arrangement. The first requirement for the bell system is to tune the fundamental resonance frequencies of each bell to an equal temperament of scale. In the previous report, Finite Element Method (FEM) was applied to determine the natural frequencies and mode shapes of the axisymmetric bell. Experimental evaluation was also carried out to examine the accuracy of the FEM calculation. Moreover, measured result showed the existence of the two orthogonal modes of which frequency difference was very small. This frequency difference generates the beat sound of the bell, which is desired to be reduced in playing music. The optimal circumferential impact point was investigated to minimize the beat sound. In this report, it is tried to shift the circumferential position of the antinodes of the lower fundamental frequency mode by adding the mass on the bell surface. If impact point of the bell is selected to this position, beat sound of the bell is expected to diminish. Moreover, damping material is attached to the location where fundamental frequency mode has the maximum strain energy and its effect to reduce beat sound is discussed.

収録刊行物

キーワード

詳細情報 詳細情報について

  • CRID
    1570572702920852736
  • NII論文ID
    110009979812
  • NII書誌ID
    AA11901770
  • ISSN
    13480235
  • 本文言語コード
    ja
  • データソース種別
    • CiNii Articles

問題の指摘

ページトップへ