Suppression of Whirling Motion of a High-Speed Rotor Suspended by Outer-Rotor-Type Magnetic Bearings

この論文をさがす

説明

Recently, smal1-sized rotating machinery such as turbomachines and flywheels are required to be driven at high rotational speeds and to maintain a clear environment. Active magnetic bearings can meet these requirements. The magnetic bearing system described here has been developed for high-speed rotating machinery. The model is a 4-axis-active type with a simple structure. Since the model is the so-cal1ed outer-rotor type, the resonance frequency of the rotor could be set higher than the rotating frequency, and only first-bending-mode frequency of the stator shaft is in the rotating region. In the high-frequency region, as the characteristics of the power amplifier become worse and the stability of the gyroscopic motion (nutation and precession) decreases, control of the flexible mode without adverse influence on another mode is very difficult. In this paper, a suppression method using stator's acceleration signal obtained from an observer circuit is discussed and compared to a conventional notch filter one.

収録刊行物

キーワード

詳細情報 詳細情報について

  • CRID
    1571980077001755392
  • NII論文ID
    110002502257
  • NII書誌ID
    AA10680610
  • ISSN
    09148825
  • 本文言語コード
    en
  • データソース種別
    • CiNii Articles

問題の指摘

ページトップへ