High speed welding of thick plates using a laser-arc combination system
-
- ABE N.
- Osaka University
-
- Agano Yasuo
- Osaka University
-
- Tsukamoto Masahiro
- Osaka University
-
- Makino Takeshi
- Kubota Corporation
-
- Hayashi Masakazu
- Kubota Corporation
-
- Kurosawa Taiga
- Kubota Corporation
この論文をさがす
抄録
Combination welding was performed using a CO_2 laser and MIG arc under various conditions to investigate the effectiveness of combining these two welding methods for high speed welding of thick plates. The penetration depth of combination welding at a low welding speed was affected by the assist gas flow rate in a manner similar to laser welding. Penetration was governed by the laser, while the bead width was governed by the arc. Laser-arc combination welding enabled the joining of 12mm thick mild steel at a welding speed of 2000mm/min after proper selection of the assist gas flow rate and root gap.
収録刊行物
-
- Trans. JWRI
-
Trans. JWRI 28 (1), 69-75, 1999
大阪大学
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1572543027162403584
-
- NII論文ID
- 110006485973
-
- NII書誌ID
- AA00867058
-
- ISSN
- 03874508
-
- 本文言語コード
- en
-
- データソース種別
-
- CiNii Articles