Reduction of Insertion Torque on Orthodontic Mini-screw Implant by means of Reduced Friction

DOI Open Access

Search this article

Description

<jats:p>In this article, the reduction of insertion torque on the orthodontic mini-screw implants (OMI) was studied. Three types of diamond-like carbon (DLC) films (DLC, Si-DLC, and F-DLC) were deposited on the OMIs by plasma-based ion implantation technique. The maximum insertion torque (MIT) value was measured using a physiodispenser during insertion on a mandibular pig jaw. Ten OMIs of each condition were used to evaluate the MIT values compared to the Ti-6Al-4V typed OMI. The statistical analysis of data was analyzed by One-way analysis of variance (ANOVA) and Tukey HSD. The results indicated that the Ti-6Al-4V showed the highest MIT but not significantly different from the F-DLC (P >0.05). DLC and Si-DLC showed a significant reduction in MIT comparing to the Ti-6Al-4V (P <0.05). However, the Si-DLC showed the lowest MIT among groups (P <0.05). This phenomenon was due to the decreasing friction coefficient during OMI's insertion on a mandibular pig jaw. Therefore, the DLC coating, especially Si-DLC, could reduce the MIT value of OMI. It is thought that the lowering friction coefficient yields the lowering of MIT value. Keywords: Diamond-like carbon, Friction, Insertion torque, Mini-screw implant</jats:p>

Journal

Details 詳細情報について

Report a problem

Back to top