プラズマＣＶＤ法により形成したタングステンシリサイド膜の評価

DOI Web Site

書誌事項

タイトル別名
  • Evaluation of W-Si Films Formed by Plasma CVD
  • プラズマ CVDホウ ニ ヨリ ケイセイシタ タングステン シリサイド マク

この論文をさがす

説明

Refractory metals and their silicides are the major candidates for low resistivity interconnect material for replacing polysilicon. Their films are commonly deposited by co-sputtering or evaporation method. In this paper, tungsten-silicide films are prepared by plasma CVD and their properties are studied by means of X-ray diffraction, Auger electron spectroscopy (AES), and Rutherford back-scattering (RBS). The film properties depend on souce gas ratio (SiH4 to WF6), discharge frequency and annealing temperature.<BR>When the source gas ratio is small (SiH4/WF6=1), pure tungsten films are obtained, whereas tungsten-silicide films are obtained, when the ratio is large (SiH4/WF6=4). By means of RBS, the ratio of Si/W is found to increases from 0.1 to 12 with the source gas ratio. When the ratio of Si/W=0.1, the resistivity decreases to 1×10-5 ohm-cm after annealing. The decreasing rate depends on deposit frequency and it is found the difference is due to the structural difference of the film.<BR>It is found by X-ray diffraction analysis that the films deposited with small gas ratio had peaks reflecting surface orientations, most intensive of which are W (200) and W (110) for those of 50 kHz and 13.56 MHz, respectively. When the source gas ratio is large, however, it shows the peaks typical of bulk tunsten at as-deposited. After annealing, only films deposited at 50 kHz show tungsten-silicide peaks.

収録刊行物

  • 真空

    真空 26 (11), 831-836, 1983

    一般社団法人 日本真空学会

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ