書誌事項
- タイトル別名
-
- Position Measurement of a Small-Diameter Tunneling Machine by using Gyroscope. Theoretical Analysis of the Measuring Error Based on a Dynamic Model of a Tunneling Machine.
- ショウコウケイ トンネル キカイ ノ ジャイロ ケイソク ニカンスルケンキュウ
- Theoretical Analysis of the Measuring Error Based on a Dynamic Model of a Tunneling Machine
- 力学モデルに基づく計測誤差の解析
この論文をさがす
抄録
For the purpose of a highly precise position measurement of a tunneling machine, this paper presents simple models of a tunneling machine s motion including the effect of conduits. There are two modes in the tunneling machine s movement. First, a doublestep forward movement mode that is used to hard soil, is studied. Its model is derived from the force/moment equilibrium acting on the tunneling machine, assuming elastic deformation of the ground. Next, a single-step forward movement mode that is applied to soft soil, is analyzed and its model is obtained by applying the minimum energy theory to the ground strain assuming both elastic and plastic deformations of the ground. By comparing the calculated results with experimental results, the feasibility of the proposed models is confirmed. Finally, the position measurements of the tunneling machine using a rate-gyroscope and a gyrocomps are studied. The measuring errors caused by the translation motion of the tunneling machine and by the discrete measurement are estimated by using our model. The analysis shows that the position measurement with the gyrocomps is more precise than that of using the rate-gyroscope.
収録刊行物
-
- 電気学会論文誌E(センサ・マイクロマシン部門誌)
-
電気学会論文誌E(センサ・マイクロマシン部門誌) 116 (8), 325-332, 1996
一般社団法人 電気学会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390001204461292032
-
- NII論文ID
- 130000771629
-
- NII書誌ID
- AN1052634X
-
- ISSN
- 13475525
- 13418939
-
- NDL書誌ID
- 4037564
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- NDL
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可