機構振動を考慮した位置制御系のＰＩとＩ‐Ｐ速度制御の比較

DOI Web Site 被引用文献3件

書誌事項

タイトル別名
  • A comparison between PI and I-P velocity controls in a position control system that considers oscillatory mechanisms.
  • キコウ シンドウ オ コウリョシタ イチ セイギョケイ ノ PI ト I-P

この論文をさがす

説明

In this closed-loop position control system, the mechanism's oscillatory characteristics were considered in the design of the control loop. Using the usual P and PI modes for position and velocity controls, the oscillations become unstable as the control gain was set larger. For (P, I-P) controls, on the other hand, those characteristics become more stable as the gain increased. For this reason, the latter can be set at higher gain for faster response. For this oscillatory mechanism having a 40 Hz natural frequency and a 0.15 damping ratio, the maximum gains were 147 s-1 using (P, I-P) and 62 s-1 in (P, PI). A stable response was obtained in (P, I-P) at a gain of 60 s-1 but severe oscillations were observed in (P, PI) at the same gain. An experiment using an X-Y table resulted in seven-times higher gain using (P, I-P) over (P, PI), and ±0.2μ m contouring error using (P, I-P) as opposed to from +3.0 to-0.5μm using (P, PI) for 10 mm-radius-circle generations at a speed of 100mm/min.

収録刊行物

  • 精密工学会誌

    精密工学会誌 54 (8), 1469-1474, 1988

    公益社団法人 精密工学会

被引用文献 (3)*注記

もっと見る

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ