The Study of the Tether Motion with Time-Varying Length Using the Absolute Nodal Coordinate Formulation with Multiple Nonlinear Time Scales
-
- KAWAGUTI Keisuke
- Department of Mechanical Engineering, Sophia University
-
- TERUMICHI Yoshiaki
- Department of Mechanical Engineering, Sophia University
-
- TAKEHARA Shoichiro
- Institute of Industrial Science, University of Tokyo
-
- KACZMARCZYK Stefan
- Division of Engineering, School of Applied Sciences, University of Northampton St.
-
- SOGABE Kiyoshi
- Department of Mechanical Engineering, Sophia University
説明
In this study, the modeling and formulation for tether motion with time-varying length, large rotation, large displacement and large deformation are proposed. A tether or cable is an important element in lift systems, construction machines for transportation and often is used with a time-varying length. In some cases, these systems are large and the tether has a long length, large deformation and large displacement. The dynamic behavior of a tether in extension and retraction using the proposed method is discussed in this paper. In the passage through resonance, significant tether motions with large rotation and large deformation result. In the analysis of this phenomenon, the transient fluctuations of the motion amplitudes are examined and compared with the corresponding steady state motions. The accuracy and the cost of the calculations are also verified by comparison with the experimental results.
収録刊行物
-
- Journal of System Design and Dynamics
-
Journal of System Design and Dynamics 1 (3), 491-500, 2007
一般社団法人 日本機械学会
- Tweet
キーワード
詳細情報 詳細情報について
-
- CRID
- 1390001205273311744
-
- NII論文ID
- 130000098921
-
- ISSN
- 18813046
-
- 本文言語コード
- en
-
- データソース種別
-
- JaLC
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可