Process Design for Preventing the Gate Oxide Thinning in the Integration of Dual Gate Oxide Transistor.

DOI Web Site Web Site 参考文献10件
  • Kim Seong-Ho
    LDI Process Architecture, LSI Development Team, SYSTEM-LSI Division, Semiconductor Business, Samsung Electronics Co., Ltd., San#24, Nongseo-Lee, Kiheung-Eup, Yongin-Si, Kyungki-Do, 449-900, Korea
  • Kim Sung-Hoan
    LDI Process Architecture, LSI Development Team, SYSTEM-LSI Division, Semiconductor Business, Samsung Electronics Co., Ltd., San#24, Nongseo-Lee, Kiheung-Eup, Yongin-Si, Kyungki-Do, 449-900, Korea
  • Kim Sung-Eun
    LDI Process Architecture, LSI Development Team, SYSTEM-LSI Division, Semiconductor Business, Samsung Electronics Co., Ltd., San#24, Nongseo-Lee, Kiheung-Eup, Yongin-Si, Kyungki-Do, 449-900, Korea
  • Kim Myung-Soo
    LDI Process Architecture, LSI Development Team, SYSTEM-LSI Division, Semiconductor Business, Samsung Electronics Co., Ltd., San#24, Nongseo-Lee, Kiheung-Eup, Yongin-Si, Kyungki-Do, 449-900, Korea
  • Park Joo-Han
    LDI Process Architecture, LSI Development Team, SYSTEM-LSI Division, Semiconductor Business, Samsung Electronics Co., Ltd., San#24, Nongseo-Lee, Kiheung-Eup, Yongin-Si, Kyungki-Do, 449-900, Korea
  • Kim Eun-Soo
    LDI Process Architecture, LSI Development Team, SYSTEM-LSI Division, Semiconductor Business, Samsung Electronics Co., Ltd., San#24, Nongseo-Lee, Kiheung-Eup, Yongin-Si, Kyungki-Do, 449-900, Korea
  • Kim Jin-Tae
    LDI Process Architecture, LSI Development Team, SYSTEM-LSI Division, Semiconductor Business, Samsung Electronics Co., Ltd., San#24, Nongseo-Lee, Kiheung-Eup, Yongin-Si, Kyungki-Do, 449-900, Korea

この論文をさがす

説明

In this study, a method is proposed to alleviate a gate oxide (GOX) thinning problem at the edge of shallow trench isolation (STI), when STI is adopted in the dual gate oxide process (DGOX). It is well known that the DGOX process is usually used for realizing both low and high voltage operating parts in one chip. However, it is found that severe GOX thinning occurs from 320 Å (in active area) to 79 Å (at STI top edge) and a dent profile exists at the top edge of STI, when conventional DGOX and STI processes are adopted. In order to solve these problems, a new DGOX process is used in this study. The GOX thinning is prevented mainly by a combination of a thick sidewall oxide with SiN pullback. Therefore, good subthreshold characteristics without a so-called double hump are obtained by the prevention of GOX thinning and a deep dent profile.

収録刊行物

参考文献 (10)*注記

もっと見る

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ