書誌事項
- タイトル別名
-
- Holding Characteristics of Porous Vacuum Chucks (In the Case of Using Water-Impermeable Porous Film as Surface-Restricted Layer)
この論文をさがす
説明
A porous vacuum chuck has an advantage that the flatness of an object held by this kind of chuck is superior to that by other types of vacuum chucks with vacuum holes or circumferential vacuum grooves. This is because porous material has through holes with micron-meter order diameter over a chuck surface. In addition, it is reported that a surface-restricted layer which has lower permeability than the bulk of the porous material can improve the holding characteristics, especially in the case of holding an object with smaller diameter than a porous chuck diameter. However, forming the surface-restricted layer is somewhat troublesome work. In addition, when a porous chuck is applied to machine tools, cutting fluid infiltrates a porous chuck and a holding force is decreased. Moreover, in cutting materials, a cutter also cuts the chuck surface and, accordingly, an air permeable sheet is usually inserted between an object and a chuck surfaces. Therefore, this paper proposes to use a water-impermeable porous film with 0.3 μm diameter holes as the surface restricted layer and the permeable sheet to overcome the above problems. The vertical and lateral holding forces are clarified numerically and experimentally. It was found that a water-impermeable porous film can easily form the surface-restricted layer for vacuum chucks and make it possible for vacuum chucks to apply to machine tools using cutting water.
収録刊行物
-
- 日本機械学会論文集Ｃ編
-
日本機械学会論文集Ｃ編 77 (775), 641-650, 2011
一般社団法人 日本機械学会
- Tweet
キーワード
詳細情報 詳細情報について
-
- CRID
- 1390001206386641664
-
- NII論文ID
- 130000873775
-
- ISSN
- 18848354
- 03875024
-
- データソース種別
-
- JaLC
- Crossref
- CiNii Articles
- OpenAIRE
-
- 抄録ライセンスフラグ
- 使用不可