給湯弁を用いる真空ダイカスト法のアルミニウム合金への適用

DOI

書誌事項

タイトル別名
  • Application of Vacuum Die Casting with Pouring Valve to Aluminum Alloy

抄録

  A vacuum die casting process, in which molten metal is sucked into an evacuated plunger sleeve via a pouring valve, has been applied to aluminum alloy. A popet type pouring valve has attained a vacuum of 1 kPa at the moment of metal injection. The properties of cast metals are compared with those produced by a conventional die casting process, having revealed that : (1) a high vacuum at injection makes the porosity finer in spite of difficulty in reducing total amount of porosity, and (2) gives finer microscopic structures and harder surfaces of metals owing to better contact of metal with mold, (3) giving better mechanical properties due merely to the elimination of solidified metal in the sleeve.

収録刊行物

  • 鋳物

    鋳物 64 (10), 718-723, 1992

    公益社団法人 日本鋳造工学会

詳細情報 詳細情報について

  • CRID
    1390001206507112192
  • NII論文ID
    130004564697
  • DOI
    10.11279/imono.64.10_718
  • COI
    1:CAS:528:DyaK3sXhsFait7g%3D
  • ISSN
    21860335
    00214396
  • 本文言語コード
    ja
  • データソース種別
    • JaLC
    • CiNii Articles
  • 抄録ライセンスフラグ
    使用不可

問題の指摘

ページトップへ