溶湯による金型の過熱量を用いた冷却管形状及び配置の最適化

DOI Web Site 参考文献9件

書誌事項

タイトル別名
  • Optimization for Shape and Arrangement of Cooling Channel Using Excessive Heat of Mould from Molten Metal
  • ヨウトウ ニ ヨル カナガタ ノ カネツリョウ オ モチイタ レイキャクカン ケイジョウ オヨビ ハイチ ノ サイテキカ

この論文をさがす

説明

This paper describes an optimization method for the shape and arrangement of cooling channels with thermal simulation. In this method, we focused on the surface temperature of a mould and used the concept of excessive heat generated by the difference from reference temperature. The excessive heat represents the quantity of heat which should be cooled by the cooling channel. Taking that this value and storage positions can be used for deciding the shape and arrangement of cooling channels, we positioned the excessive heat in the mould and substituted the mould area with a cooling channel according to the excessive heat threshold. We defined the total average of temperature deviation at the mould surface as an objective function and updated the shape and arrangement of the cooling channel to minimize the objective function. <br>  In order to confirm the validity of this method, we attempted 2D simulation with a hook-shaped cavity. We calculated the shape and arrangement of the cooling channel by this method and confirmed that temperature deviation becomes smaller. <br>  We also conducted experiments on a pseudo model to confirm the validity of this method. Taking the test piece to be a part of the mould, we substituted the casting product which heats up the mould surface with a burner. We obtained the optimum shape and arrangement of the cooling channel through simulation and built the test piece based on the simulation results. The temperature deviation at the measuring points of this experiment was small and the performance of the cooling channel was good.

収録刊行物

  • 鋳造工学

    鋳造工学 83 (1), 13-19, 2011

    公益社団法人 日本鋳造工学会

参考文献 (9)*注記

もっと見る

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ