書誌事項
- タイトル別名
-
- Machinability of Small Diameter Hole for Circuit Connection in Multi-Layer AFRP Printed Wiring Boards. Comparison between Kevlar Fiber and Thecnora Fiber Reinforcement.
- AFRP タソウ プリント キバン ノ カイロ セツゾクヨウ ショウケイ アナ ノ カコウ トクセイ ケブラー センイ オヨビ テクノーラ センイ キョウカ キバン ノ ヒカク
この論文をさがす
抄録
In the current manufacture of multi-layer printed wiring boards, the method frequently used to laminate the core with insulating resin as build-up layer. However, a problem has emerged in that the strength of the substrate decreases due to the insulating resin part as the multi-layers are progressively formed. Thus, it becomes necessary to use FRP for the insulation layer part. Especially among various kinds of FRPs, AFRP has been considered a suitable FRP because of its low coefficient of linear thermal expansion in the x-y plane. On the other hand, there are various kinds of aramid fibers used to reinforce the plastics. Kevlar fiber and Thecnora fiber are well known among them. Therefore, this paper describes the small diameter drilling in the printed wiring board made of Kevlar fiber reinforced plastics and Thecnora fiber reinforced ones. Especially this report dealt with the blind via holes formed by CO2 laser and the through hole drilled by a conventional drill tools. The machinability of two types AFRP was compared in small diameter drilling for circuit connection.
収録刊行物
-
- 日本機械学会論文集A編
-
日本機械学会論文集A編 68 (666), 258-265, 2002
一般社団法人 日本機械学会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390282679424488064
-
- NII論文ID
- 110002370071
-
- NII書誌ID
- AN0018742X
-
- ISSN
- 18848338
- 03875008
-
- NDL書誌ID
- 6083195
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- NDL
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可