Properties of TaN Films for ULSIs Prepared by Reactive Sputter Deposition

DOI Web Site Web Site 被引用文献1件 参考文献1件
  • Tajima H.
    Department of Electronics and Bioinformatics, School of Science and Technology, Meiji University
  • Shiobara N.
    Department of Electronics and Bioinformatics, School of Science and Technology, Meiji University
  • Katsumata H.
    Department of Electronics and Bioinformatics, School of Science and Technology, Meiji University
  • Uekusa S.
    Department of Electronics and Bioinformatics, School of Science and Technology, Meiji University

この論文をさがす

抄録

Tantalum Nitride (TaN) thin films were deposited onto n-type Si(100) and (111) substrates with SiO2 films at room temperature by radio frequency (RF) magnetron sputtering under Ar-N2 plasma using a tantalum target. We observed the formation of TaN thin films with a wide range of the electrical resistivity as a function of the N2 gas flow ratio, working pressure and the sputtering power, and their origins are discussed based upon the structural properties and chemical compositions of TaN thin films before Cu films deposition. In this study, we first observed that the TaN thin films with lower resistivity exhibited TaN(200) preferentially oriented structures and had larger grain sizes. It was also found that the formation of TaO(002) made the resistivity of TaN thin films higher because of the diffusion of oxygen from SiO2 films during deposition.

収録刊行物

被引用文献 (1)*注記

もっと見る

参考文献 (1)*注記

もっと見る

詳細情報 詳細情報について

問題の指摘

ページトップへ