Difference in Grinding Mechanism between Up- and Down-cut Creep Feed Grindings
-
- SHIOZAKI Susumu
- 正会員 東京都立大学工学部
-
- FURUKAWA Yuji
- 正会員 東京都立大学工学部
-
- OHISHI Susumu
- 正会員 東京都立大学工学部
Bibliographic Information
- Other Title
-
- クリープフィード研削における上向きおよび下向き研削機構の相違
- クリープ フィード ケンサク ニ オケル ウワムキ オヨビ シタムキ ケンサク
Search this article
Abstract
This paper aims to reveal the difference in grinding mechanism between up- and down-cut creep feed grindings. According to the experiments, both the normal and tangential components of mean grinding force have always become larger in up-cut than in down-cut under the usual creep feed grinding conditions, and the difference has become 1. 7 times at maximum. It was found from the force measurements on a single grain that its normal to tangential ratio remained constant at about 2.5 throughout a grain-workpiece engagement in down-cut, but it became up to about 7 at the beginning of engagement in up-cut, which implies much occurrences of rubbing and/or plowing, hence leading to a larger grinding force. Then it is introduced that this mean grinding force at down-cut can be estimated quantitatively from the conventional grinding force data.
Journal
-
- Journal of the Japan Society of Precision Engineering
-
Journal of the Japan Society of Precision Engineering 45 (533), 599-606, 1979
The Japan Society for Precision Engineering
- Tweet
Details 詳細情報について
-
- CRID
- 1390282679740864256
-
- NII Article ID
- 130003961501
- 110001290628
-
- NII Book ID
- AN00130014
-
- NDL BIB ID
- 2051907
-
- ISSN
- 03743543
-
- Text Lang
- ja
-
- Data Source
-
- JaLC
- NDL
- Crossref
- CiNii Articles
-
- Abstract License Flag
- Disallowed