金型用焼入れ鋼のエンドミル加工に関する研究  SKD11とSKD61の比較

書誌事項

タイトル別名
  • A Study on End-milling of Hardened Steels. Comparison of SKD11 and SKD61.
  • カナガタヨウ ヤキイレ コウ ノ エンドミル カコウ ニ カンスル ケンキュウ SKD11 ト SKD61 ノ ヒカク
  • Comparison of SKD11 and SKD61
  • SKD11とSKD61の比較

この論文をさがす

抄録

This study deals with the characteristics of end-milling the hardened steels (SKD11 and SKD61: HRC53). The experiment under various cutting speeds was done in order to estimate the relationship between the cutting distance and the cutting speed. The cutting forces and the chip temperature were measured in the experiment. The hardness of the chip was also researched after cutting. The tooth form of the used tool and the cutting fluid were varied to estimate the deposition of the materials. Furthermore, the carbide including the chip was observed by AFM and the microscope. As a result, it is clear that the carbide included in SKD11 makes it difficult to end-mill comparing SKD11 and SKD61.

収録刊行物

  • 精密工学会誌

    精密工学会誌 67 (5), 834-838, 2001

    公益社団法人 精密工学会

被引用文献 (7)*注記

もっと見る

参考文献 (4)*注記

もっと見る

詳細情報 詳細情報について

問題の指摘

ページトップへ