TiC系サーメットによる正面フライス削りの研究

DOI DOI Web Site Web Site Web Site

書誌事項

タイトル別名
  • Utilizing TiC Cermet Tool Material in Face-Milling
  • TiCケイ サーメット ニ ヨル ショウメン フライス ケズリ ノ ケンキュウ

この論文をさがす

抄録

Providing a bevel land at a cutting edge strengthens the edge against impacts. It enables a more unwearable but brittler tool material to be employed in face-milling for a better milling performance. As example of this potential developement, TiC cermet is studied to be utilized in face-milling of steels. A single braded cutter is used in fundamental experiments, where the effects of the bevel land and the radial rake on cutting forces, low speed breakage and high speed breakage, and the comparison between the cermet and several carbides are studied. Based on the results of those tests, a throw-away type cermet cutter is made so as to obey practical demands. A test run of the cutter apparently proves its utility.

収録刊行物

詳細情報 詳細情報について

問題の指摘

ページトップへ