-
- YOSHIDA Hiroaki
- Fujitsu Laboratories of America
-
- WAKIZAKA Masayuki
- Graduate School of Ritsumeikan University
-
- YAMASHITA Shigeru
- Graduate School of Ritsumeikan University
-
- FUJITA Masahiro
- VLSI Design and Education Center, The University of Tokyo
抄録
With the shorter time-to-market and the rising cost in SoC development, the demand for post-silicon programmability has been increasing. Recently, programmable accelerators have attracted more attention as an enabling solution for post-silicon engineering change. However, programmable accelerators suffers from 5∼10X less energy efficiency than fixed-function accelerators mainly due to their extensive use of memories. This paper proposes a highly energy-efficient accelerator which enables post-silicon engineering change by a control patching mechanism. Then, we propose a patch compilation method from a given pair of an original design and a modified design. We also propose a design method to add redundant wires in advance to decrease the necessary amount of patch memory for post-silicon engineering change. Experimental results demonstrate that the proposed accelerators offer high energy efficiency competitive to fixed-function accelerators and can achieve about 5X higher efficiency than the existing programmable accelerators. We also show the trade-off between redundant wires and the necessary amount of patch memory.
収録刊行物
-
- IEICE Transactions on Fundamentals of Electronics, Communications and Computer Sciences
-
IEICE Transactions on Fundamentals of Electronics, Communications and Computer Sciences E97.A (12), 2507-2517, 2014
一般社団法人 電子情報通信学会
- Tweet
詳細情報
-
- CRID
- 1390282681287066752
-
- NII論文ID
- 130004706414
-
- ISSN
- 17451337
- 09168508
-
- 本文言語コード
- en
-
- データソース種別
-
- JaLC
- Crossref
- CiNii Articles
- KAKEN
-
- 抄録ライセンスフラグ
- 使用不可