Effects of built-up edge on cutting process of various aluminum alloys.
-
- YAMADA Shigeru
- Mechanical System Engineering, Fuculty of Engineering, Toyama University
-
- MIZUTANI Hideyuki
- Mechanical Engineering, College of Engineering, Chubu University
-
- NOTOYA Hisakimi
- Mechanical System Engineering, Fuculty of Engineering, Toyama University
-
- TAKAYANAGI Akira
- Tokai Rubber Industries, Ltd.
Bibliographic Information
- Other Title
-
- 各種アルミニウム合金の切削過程に及ぼす構成刃先の影響
- カクシュ アルミニウム ゴウキン ノ セッサク カテイ ニ オヨボス コウセイ
Search this article
Description
The built-up edge in machining of an aluminum alloy is an important problem, and its shape affects the cutting state of the alloy. The aim of this study is to elucidate the main cause of the shape change of the built-up edge. The effect of the shape of the built-up edge on the cutting process was also investigated. The shape of the built-up edge can be roughly classified into two types: the wedge type and nose type. The machining of Al-Mg alloys results in the formation of the wedge type built-up edge which remains on the tool face. The addition of Si or Bi to a work material of an aluminum results in the formation of the nose type built-up edge. The wedge type built-up edge was observed in machining of alloys with high hardness and high work hardenability. While the cutting force, surface roughness and affected-layer depth decrease in the case of the wedge type built-up edge, these values increase in the case of the nose type built-up edge.
Journal
-
- Journal of Japan Institute of Light Metals
-
Journal of Japan Institute of Light Metals 43 (4), 206-212, 1993
The Japan Institute of Light Metals
- Tweet
Details 詳細情報について
-
- CRID
- 1390282681312584064
-
- NII Article ID
- 130004075949
-
- NII Book ID
- AN00069773
-
- ISSN
- 18808018
- 04515994
- http://id.crossref.org/issn/04515994
-
- NDL BIB ID
- 3822471
-
- Text Lang
- ja
-
- Data Source
-
- JaLC
- NDL
- Crossref
- CiNii Articles
-
- Abstract License Flag
- Disallowed