書誌事項
- タイトル別名
-
- Effects of built-up edge on cutting process of various aluminum alloys.
- カクシュ アルミニウム ゴウキン ノ セッサク カテイ ニ オヨボス コウセイ
この論文をさがす
説明
The built-up edge in machining of an aluminum alloy is an important problem, and its shape affects the cutting state of the alloy. The aim of this study is to elucidate the main cause of the shape change of the built-up edge. The effect of the shape of the built-up edge on the cutting process was also investigated. The shape of the built-up edge can be roughly classified into two types: the wedge type and nose type. The machining of Al-Mg alloys results in the formation of the wedge type built-up edge which remains on the tool face. The addition of Si or Bi to a work material of an aluminum results in the formation of the nose type built-up edge. The wedge type built-up edge was observed in machining of alloys with high hardness and high work hardenability. While the cutting force, surface roughness and affected-layer depth decrease in the case of the wedge type built-up edge, these values increase in the case of the nose type built-up edge.
収録刊行物
-
- 軽金属
-
軽金属 43 (4), 206-212, 1993
一般社団法人 軽金属学会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390282681312584064
-
- NII論文ID
- 130004075949
-
- NII書誌ID
- AN00069773
-
- ISSN
- 18808018
- 04515994
- http://id.crossref.org/issn/04515994
-
- NDL書誌ID
- 3822471
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- NDL
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可