Fe-Al-Ni焼結磁石の焼結過程に伴う密度,電気抵抗および組織の変化

書誌事項

タイトル別名
  • The Dependence of Density, Electrical Resistivity, and Microstructure Upon the Process of Sintering in Fe-Al-Ni Magnet Alloy
  • Fe-Al-Ni ショウケツ ジシャク ノ ショウケツ カテイ ニ トモナウ ミツド , デンキ テイコウ オヨビ ソシキ ノ ヘンカ

この論文をさがす

抄録

The process of sintering in FeAl2-Ni-Fe system (Al 12%, Ni 25%, Fe 63%) is discussed in this paper from the experimental stand-points; i.e. the dependence of various properties (density, electrical resistivity, microstructure) upon the sintering process of water-quenched specimens from their sintering temperature has been investigated. The conclusions obtained were as follows: (1) At the sintering temperature of 700°C, a decrease down to 1/26-1/58 of the green compacts in electrical resistivity at was already observed, suggesting that the diffusion of the components has set in . (2) When the sintering temperature reached 1250°C, rapid alloying of component particle, i.e. the reactions of FeAl2 phase+Ni phase→α′ phase, and α′ phase+Fe phase (γ)→α phase have been observed, and after sintering at 1350°C for 90 min the specimens consisted of α phase only. (3) The effect of compacting pressure upon the sintering process of the FeAl2-Ni-Fe system where no liquid phase is was existence has been found to be larger than that when a liquid phase was in existence. (4) The effect of sintering temperature upon the sintering process of the FeAl2-Ni-Fe system has been found to be larger than that of sintering time.

収録刊行物

  • 日本金属学会誌

    日本金属学会誌 23 (4), 199-203, 1959

    公益社団法人 日本金属学会

被引用文献 (1)*注記

もっと見る

詳細情報 詳細情報について

問題の指摘

ページトップへ