Effect of Spinning Condition on the Shape of Metal Wire Produced by the In-Rotating-Water Spinning Method
-
- Takamatsu Hiroshi
- Institute of Advanced Material Study, Kyushu University
-
- Cho Kyu-Sang
- Interdisciplinary Graduate School of Engineering Sciences, Kyushu University
-
- Yamashiro Hikaru
- Institute of Advanced Material Study, Kyushu University
-
- Honda Hiroshi
- Institute of Advanced Material Study, Kyushu University
Bibliographic Information
- Other Title
-
- 回転水中紡糸法で製造された金属細線の形態に及ぼす製線条件の影響
- カイテン スイチュウ ボウシホウ デ セイゾウサレタ キンゾク サイセン ノ
Search this article
Abstract
Metal wires of Pb, Zn and Fe_<77.5>Si_<7.5>B_<15> were produced by the In-Rotating-Water Spinning Method. The effects on the shape of wire of drum velocity (5.2-8.5m/s), jet ejection velocity (3.5-10.0m/s), incidence angle (30, 45, 60 deg) and nozzle diameter (0.1 and 0.2mm) as well as the kind of metals were examined. Pb showed the best spinnability among the tested metals, although the cross section was relatively flat and marked ripples were formed on the wire surface when the incidence angle and jet velocity were relatively large. A long, straight Fe_<77.5>Si_<7.5>B_<15> wire that had smooth surface and round cross-section was obtained with a 0.2-mm-dia. nozzle when the jet velocity and the drum velocity were almost the same. The Fe_<77.5>Si_<7.5>B_<15> wire produced with a 0.1-mm-dia. nozzle however showed the shape like a string of beads.
Journal
-
- 九州大学機能物質科学研究所報告
-
九州大学機能物質科学研究所報告 9 (1), 13-20, 1995-11-15
Institute of Advanced Material Study Kyushu University
- Tweet
Details 詳細情報について
-
- CRID
- 1390853649765704064
-
- NII Article ID
- 110006177459
-
- NII Book ID
- AN10060378
-
- ISSN
- 09143793
-
- DOI
- 10.15017/6667
-
- HANDLE
- 2324/6667
-
- NDL BIB ID
- 3915744
-
- Text Lang
- ja
-
- Data Source
-
- JaLC
- IRDB
- NDL
- CiNii Articles
-
- Abstract License Flag
- Allowed