Improvement in Copper-Resin Bond Strength after High-Temperature Testing Using C–H–Si Thin Film

DOI Web Site Web Site 被引用文献1件 参考文献16件
  • Yamada Yuka
    Materials and Manufacturing Science, Graduate School of Engineering, Osaka University
  • Fukumoto Shinji
    Materials and Manufacturing Science, Graduate School of Engineering, Osaka University
  • Fujimoto Kozo
    Osaka University

この論文をさがす

説明

<p>The bonding between copper and epoxy resin is investigated using a C–H–Si thin film to achieve highly adhesive and reliable bonding between the resin mold and the copper substrate in power modules. In this study, high-temperature (473 K) testing is performed to improve the reliability of this junction after high-temperature operation. The bond strength decreases and delamination occurs at the film–copper interface after high-temperature testing. The decrease in bond strength may be due to the decrease in the film–copper interfacial strength because of the decrease in the binding force between copper and oxygen upon heating. When Fe and Cr, which have high oxygen bond disassociation energies, are intercalated at the film–copper interface, the bond strength improves after high-temperature testing and a bond strength above 30 MPa was retained after 1000 h.</p><p>This study is a novel method of dissimilar bonding based on chemical and physical effects of C–H–Si film existing between copper and resin. Further, it is an effective method of bonding to achieve high-temperature operation of a resin-molded power module, which can contribute to future advancements in power electronics products.</p>

収録刊行物

  • MATERIALS TRANSACTIONS

    MATERIALS TRANSACTIONS 63 (6), 754-758, 2022-06-01

    公益社団法人 日本金属学会

被引用文献 (1)*注記

もっと見る

参考文献 (16)*注記

もっと見る

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ